1) Use your battery drill.
2) Slip a Zip-Ez™ all-purpose fastener over a screw.
3) Shoot it through with your drill.
Note: Extreme over-torquing may cause cracking.

1) To install duct wrap or fiber-free reflective insulation with Zip-Ez™, wrap the ductwork or wrap around the trunk duct.
2) Leave a 2" overlap where the ends meet.
3) Secure with Zip-Ez™ fastener, covering the overlapping edges.
4) For best results, use a Zip-Ez™ fastener every 8-12 inches. This will secure the wrap permanently!
Note: For wrap thicker than 1.5 inches, use Zip-Ez™ face down.

1) Pull back jacket and insulation from the core. Slide at least 1" of core over collar, pipe or fitting.
2) Tape core with at least 2 wraps of duct tape.
3) Secure with 2 or more Zip-Ez™ fasteners.
4) Pull jacket and insulation back over core.
5) Secure with 2 or more Zip-Ez™ fasteners. Typical installation would be inner core 12 and 6 o’clock, outer jacket 3 and 9 o’clock.

DUCT WRAP INSTALLATION (English)

DUCT WRAP INSTALLATION (Español)

REFLECTIVE INSTALLATION (English)

DUCT BLASTER TEST VIDEO

Each bag of Zip-Ez™ fasteners weighs 1.87 pounds and contains approximately 250 pieces. This patented product is manufactured in the USA from UL listed materials.

J.T. Products, Inc. proudly uses the services of ARC of Rockland.